E99 Avant with:
-SP Teardrop
-Egg II
-Kingman ACS Delrin Bolt
-32 Degrees Bob Long Style Xpansion chamber
-Dye Stickies
-Shocktech trigger
-20oz CO2
-Macroline kit
-DOP Drop forward
-Spring kit
Strengths:
-Easy walking
-Easy installation
Weaknesses:
-Needs extra washers because of wobbling.
Review:
Wow, This trigger is one fine piece of work. Shocktech really did their homework on this one. This trigger will improve your BPS drastically. This cheap,stylish trigger improved my rate of fire by about 5 BPS. Other than being a good trigger, it's so easy to install.
Installation: (Note that this installation is for the E99 Avant, not completely sure it will be the same for the other guns, it most likely is though)
1. get a hammer and a metal punch or screwdriver ready. Maybe a thin clothe to wrap the metal punch in, so you dont damage the gun if you miss.
2. punch out the pin holding the trigger from the side of the gun with the whole warning paragraph (may take a few hard hits)
3. remove existing trigger and spring and transfer spring to new trigger and put the pin back in from the opposite side with washers (extras may need to be purchased).
4. enjoy
*****BE VERY CAREFUL YOU DONT SMASH THE GUN WITH THE HAMMER*****
NOTE : Extra washers can be purchased at any hardware store
Conclusion:
This trigger something you should look into if youre looking to improve your rate of fire. THIS IS A MUST BUY!!!!!
Rating:
10 out of 10
Last edited on Saturday, July 2nd, 2005 at 2:32 pm PST
