|
|
Period of
Product Use: |
| Less than a month | 1 of 5 people found this review helpful.
|
|
|
Paintball
Experience: |
More than 5 years |
|
Similar
Products Used: |
stock brass pulley |
|
| Marker Setup: |
Ion, SP 360 QEV, X-11 drop, clamping feedneck, VP scythe trigger, Halo B w/overdrive pulley and shocktech spring |
|
|
|
|
| Strengths: |
Feeds 2 bps more |
|
| Weaknesses: |
Doesnt fit on brass pulley read review |
|
| Review: |
When i opened it up I was expecting something bigger but it works. Ok no where else tells you how to install it so I will.
1. Split hopper into 3 pieces (left shell, right shell, and blue thing w/ drive cone)
2. Unscrew 3 screws on bottom of blue thing and take electrical tape off
3. See if it fits firm over brass pulley if not the put teflon tape over pulley and slide on new delrin one.
4. Put belt on pulley and then put the white thing that the belt also goes on in the pin thing it belongs on then stretch the belt over it and put it on.
5. Screw and connect everything w/o putting on shell and turn it on (as a test)
6. If it works put it back together and go play
I hope these instructions helped you |
|
| Conclusion: |
I give it a 9 bc it didnt fit right and it had no instructions |
|
| Rating: |
|
|
|
|
|
|
