Spyder Rodeo
Teardrop Barrel
Evil Detonator
Trinity 7D Front Block
Trinity Feedneck
Halo TSA Backman Hopper
Dye stickies
Bandit High Flow Valve
32* Spring Kit
Kingman IPI frame
72/3000 PMI
Strengths:
High Flow
cost
Weaknesses:
Didn't quiet the marker like had expected
Very tedious recocking problems
Review:
This valve is machined perfectly. I installed it quickly and easily. The easiest way is to pay attention to the old valve. Im not going to say this is a poor valve. It is well made, and it is inexpensive and there is definately a flow increase. However, After installing and using for quite awhile actually, I noticed that occasionally there would be a slight recocking issue on the first shot after putting my compressed air tank on. After that it was ok. My velocity was already high, so I couldnt increase the pressure. I tried every spring combo and couldnt work it out. So I replaced the stock valve and springs, which seems to have resolved the problem.
If anyone has ideas, or knows of a spring combo that might work for that problem, please comment
Conclusion:
It was extremely cheap so you don't have much to lose. Definate flow increase.
Ill give it an eight because of my problem which is probably my fault or my guns fault
Rating:
8 out of 10
Last edited on Tuesday, February 5th, 2008 at 7:37 am PST
