Comments on cfa247's Review

cfa247 Wednesday, July 16th, 2008 Period of Product Use: Less than a month 15 of 15 people found this review helpful. Paintball Experience: 2 years Marker Setup: Smart Parts Ion Powerlyte Body Kit Q-Lock Max- Flo Reg Shocktech Reg Max Flo Compatible 47/3000 Tank All-American Barrel Halo B Loader Wave Roller Trigger But that got stolen =[ so now I use... Smart Parts Ion Pewter Dynasty Body Kit All American Barrel Max Flo Micro 3000 psi Reg Max Flo Micro Compatible Tank 47/3000 EvLution 2 Loader Q-Lock Strengths: VERY HARD to fog up Easy to remove lenses Feels very comfortable Weaknesses: Kind of bulky and weighs a lot more than other masks out there Review: I've tried to fog up these goggles on purpose, but they just never seem to fog up! The only time when i've had a problem seeing through them was when I was playing outside and it was like close to 100 degrees and i had sweat from my hair going onto the lenses( I have long hair) The goggles are also very comfortabe; they have a tri-mold material that is very soft and offers good protection The 1/4th buckle also makes it very easy to remove the lenses; I can easily remove them in under a minute! If you look down in some other reviews though, you'll see that some of them mention that water will get inbetween the lenses. THIS IS TRUE! I even got shot in the lens one time and i got paint in between the thermal lenses! This was very annoying because I had no way of cleaning it at the field. When i got home i finally washed them and water got inbetween the lenses and I had to wait for it to evaporate for a while and it left some light water streaks, but oh well UPDATE: I found a good way to fix up the seal to prevent water from coming into the lens. Just make sure you dont currently hve a warranty b/c this probably violates it. Just put some epoxy glue into the small opening into the seal(enough to clog up the hole and also to hold the two lens pieces together. Be careful not to get it too far up into the lens or it'll block up where you look out. Keep it towards the edges. Next, just take some scotch tape and use it to clamp the two lens pieces together closer and wait a day for the glue to dry. A day probably isn't necessary but just in case.... Conclusion: great mask, I just wish the water and paint hadn't gotten in between the lens This lens is still worth a ten Please rate this review helpful if you found it to be Rating: 10 out of 10 Last edited on Thursday, August 21st, 2008 at 6:40 pm PST