|1 of 1 people found this review helpful.|
||-This piece was the last piece I need to complete my Slampak system
-By far i thinks it the crappiest piece in the whole system
What's good? hmm lets see.
-The timer looks cool
-It comes in a nice package
-It's fun to slam pods into it.
-When the pod jams you can just play with the pod stick'in out
-People talk to you cause they wonder'in what the hell it is.
||-One of the crappiest JT products.
-Should either be cheaper or better quality.
-25 dollars? geeez
-My lid fell apart by just playing with it (before installation)
-It doesn't fit on the 12v Loader (without mods)
-No insturctions? Well i managed w/o it but it'd be nice for others
-Comes with GOT timer that only worked once when i first opened it.
-GOT timer looks like a $1 watch from K-mart
-GOT timer has 2 buttons yet it's still confusing (no instructions)
-I struggled to turn it off i mean come on.
-You actually had to sit there and think how the hell u were to install this thing
-Jt Could have improved this design.
-Worthless crappy Timer and Crappy lid.
-If it only fits the 12V and 9V Loaders why not make the stupid thing fit good?
||Well I'd buy it if you have a slampak and speedpods. But if you don't then don't get this thing. It's a piece of crap but it works with some mods.
Problem: There something in the way so when you put in on the hopper the holes on the bottom are barely on the hopper. So if you drilled into it. You'll mess up the hopper.
What i did to make this thing work.......
You can use a dremel tool to scarap the middle bottom section cause that's what's in the way. You could use a file and fille it down.
Or you can remove the GOP timer (held on with double sided tape) open it up (remove 4 screws) and cut the inside bottom section with pliers (I did this because i didn't have a file or dremel tool) But all ways would work.
The bottom section looks like this [____|____] it's under the GOP Timer.
Now after you've done that you should have the holes line up the loader pretty good and the fit should be snug. I lost the long screw that came with it so i'll go buy another one. But the bottom hole line up with the screw so i took the Loader's screw and used that for now. After that you would drill a hole all the way through the hopper. and screw in the long screw.
Problem: Broken Lid (cheap Lid)
Mine fell off well i took it off because it would eventually. Theres a small pin that holds the lid on it's crap. I took the pin out and used a paper clip. I opened the paper clip stuck it through the holds and made a loop at each end with needle nose pliers so the paper clip won't fly out.
Alternative option: Just play without the cheap lid.