oooooooook!!!! what is up with u peeps givin Ans a bad name. This front block kicks azz big time i swear. I putta bechmark 45 grip frame a new bolt a boomstick and this front block on my cocker and it rules the first shot i took with this thing on my gun gogled my dad right between the eyes i swear. I just cant say enough good stuff bout this reg it costs about 80 $$ less than the kapp front block and it is better than the kapp front block. Its also adjustable so u dont have to fool around with takin apart the whole back of the gun to adjust the velosety if u have a 2001 cocker like me that is a big plus. these things are really beautiful too especialy the low preshure version which makes the gun more eficiant.
ok i admit this thing is hard to install if you dont know exactly how the cocker works have a qualified air smith install it for you it will suck sooooo bad if u dont install it right for all u peeps that didnt have a good experiance with this front block try instaling it again or take it to an air smith. To install this thing right first take the old front block off by unscrewing the large black screw at the front of ure gun that connects the block to the rest of the gun next disasemble the back of the gun like u were about to adjust the velocety after u have taken the rod off that comes out the back of the gun then take the bolt out by pressing the lottle pin in that connects the back block to the bolt pull the pin out then take the bolt out next unscrew the black, back -block from the cocking rod that goes down the side of the gun then unscrew the cocking rod from the ram rod which is also a metalic rod now flip the gun over and remove the two allan wrench srews (they are really small) that connect the rod that comes out of the triger to the 3 way after uve done that take the trigger frame off by unscrewing the screw that is located at the back of the handle and the one under the trigger guard (near the trigger) thenpull that away from the pin valve that comes out the back of the trigger the old front block should now fall off just do the opposite to install the front block be sure to use teflon tape on the threads of the big screw that u unscrewed first also put the pin valve in the 3 way up as far as u can into the three way before u bolt it to the rod that comes out the trigger frame u might also have a problem with adjusting the cocking rod but just keep expirimenting til it works.
If u have no clue how the cocker works u should let an air smith do all this stuff but i garentee that once that thing is installed right it will make ure gun shoot better than ever il see u on the field -Josh
10 out of 10
Last edited on Saturday, January 29th, 2005 at 6:47 am PST