Stock WGP inline
ANS Gen-X2
Ergo
Sidewinder
MaxFlo
Marker Setup:
Shocktech rf red cocker
HP 3-way, Tickler LPR, Evolution ram, SupaFly, REX hammer kit, RED valve, WGP hinge, GLADIATOR
Kapp on/off w/ PE 88/4500
Halo-B
Strengths:
Extremely Consistent. I'm +/-2or3 every day!
Low Pressure, very accurate adjustment
Simple assembly and cleaning.
SUPER high Flow, I have almost NO dropoff at 8bps
hot looking.
Good foregrip
Weaknesses:
Gotta have clean air.
Gotta keep it clean.
Allen key isn't in a convienient spot for some people's ASA's. But it works fine for me.
Conclusion:
It kinda ENRAGES me that people would give this regulator a 2 or a 4 out of 10... This reg is in the top two regs on the market.
Read the description, this regulator is made for high performance Low pressure markers. NOT TIPPMANS!
Two, This regulator can only give a maximum output of 500psi, it cannot creep up to 800psi. If it was creeping at all then you've got drit in it or a bad seat/o-ring.
Do not get this regulator unless you will run your gun under 350psi
This reg will out-perform a Gen-x2 at 2/3 the cost, and can match the MaxFlo.
A note to a guy below me... YOU'VE GOT AN 88/4500 MAX FLO! WHY ARE YOU DOUBLE-REGGING A MAX FLO?!?!?!?! JEEZ MAN....
