|
|
The accuracy of this review is disputed. Please see discussion below.
|
Period of
Product Use: |
| Less than a month | 10 of 11 people found this review helpful.
|
|
|
Paintball
Experience: |
More than 5 years |
|
Similar
Products Used: |
Low pressure valves for spyders |
|
| Marker Setup: |
Tippmann A-5, E-grip, Low Pressure Kit, Palmer Stablizer, Pure Energy HPA, 32 degree drop forward, Freak Barrel, BSA red dot |
|
|
|
|
| Strengths: |
Reduces recoil, increases accuracy and improves air efficiency |
|
| Weaknesses: |
Shifts balance point forward and you need to unscrew vertical adapter to field strip. |
|
| Review: |
This kit works great, it was easy to install and allowed me to lower input pressure from 600psi to 350psi. The new valve is very efficient, my velocity at 350 psi input was 375 fps with the velocity screw backed all the way out. You really should use an RVA or spring kit with this set-up to further increase your efficiency. I can now shoot a full case of paint out of my 68ci 5000psi tank. The marker has much less recoil and drop off has been reduced so long strings of paint stay on target. The only down side is that you need to unscrew the vertical adapter to strip the marker, no more 4 pins in 30 seconds. You will need a secondary regulator and HPA to run this kit, if your bottle has an adjustable reg you could screw in an ASA adapter with a 1/8 npt fitting to the vertical adapter, then you would not need a second reg. |
|
| Conclusion: |
This kit works great and would make a good addtion to an A-5 already running HPA. |
|
| Rating: |
|
|
|
|
|
|
