custom screwing up [Archive] - Paintball Forums

greatonekyle

11-29-2002, 05:17 PM

i went out to play today and i just added a jet city stock and went i got ready to play my gun wouldnt shoot, it would cock and when i pulled the trigger it would shoot without any air...it was a new tank too. so i thought maybe it was the stock so i went and took it off and replaced it with the butt cap, it shot but when it did it would either shoot very slow as in lobbing the balls and only make it like 50-75 feet, or it would barely shoot and uncock, or just wouldnt shoot at all...whats wrong with my tippmann?!

Alexi1337

11-29-2002, 06:45 PM

Check your rear-bolt O-ring and make sure you put everything back in your gun right.

paintmepurple

11-29-2002, 08:27 PM

make sure all of you hose fittings are tight and not leaking. put some loctite on the valve inlet. it could be a problem with the valve pin not going in far eneugh, not sure what to do to test that. it could be teh tank not letting eneugh air in.

E r y k

11-30-2002, 08:13 AM

lobbing balls?

ball latch

greatonekyle

11-30-2002, 11:28 AM

all it was, the valve screws were loose and my ball latch was in backwards and broke which sucks but at least my gun works right