Question abou the SideWinder Regulator.

[Tim618]

Hi, i gotta question about the sidewinder reg, in the pic shown..here: http://www.pbreview.com/645/1/0/ it has a nipple on it, do you have to change that to the macro fitting to get macro line on it?

[ayzian]

I think that's quick disconnect but I'm not sure

[Tim618]

yeah ok it prolly is i dunno though, so that means id have to change it to put macro line on it then?

[king]

You will have to change the quick connect fitting too a macro line fitting!

[Tim618]

ok thank you, that shouldnt be that hard...i hope :eek:

[king]

Easy as turning a door knob.:laugh:

[CoolT357]

No this is what I would do. Buy the other end of the quick disconnect, should look like this:

http://store6.yimg.com/I/actionvillage_1720_173936416

Then attach the macro line 90* fitting onto the end of that. Then you will have a quick disconnect macro line :) You could also just take off the quick disconnect nipple and add on a macro line 90* fitting but personally the quick disconnect macro line is nicer.

[king]

A macroline fitting is already qiuck-disconnect! The macroline just slides into or out of the fitting.

[ShootPaint]

Not to mention, if you do a multi connection like listed above you would want some kind of a check valve so you could shut the gas off whenever you disconnect the hose.