I hate this particular aspect of electronic guns

[HellFish]

My dang wire ripped out of my plug wire harness plug on my bko (the plug that hooks to the circuit board, the wire that hooks from that plug to the solenoid ripped out again) I wish they used thicker wires so this wouldnt happen as easily. Does anyone know how I can fix this. I need it fixed fast.


-HellFish

[SPS16]

Yea that really sucks, i've had that happen before. What you can do is to solder the wire back into the harness, that way next time it won't pull out :D

[HellFish]

I would but i dont have anything sticking out of the plug to solder to and my friend was like if u have never used a soldering iron dont try to do it. And I cant get in contact with vaporworks, ICD, nor can I find a place that has wire harness's. so I dont know what to do?

-HellFish

[ayzian]

call up ICD... they should help

[gregicd]

Why were you inside the tray? To replace the battery is the only reason you need to even be inside the marker and it isn't even in the tray. Sounds like you need to be more carefull. Don't blame the wiring harness it isn't designed to be pulled on.

Just becarefull and solder it back on. Just be patient and steady handed and you can fix it.

[SPS16]

I don't know where your located but you could try www.eastcoastpaintball.com

[HellFish]

I had to take the gun all apart to get my roll pins out of my trigger and microswitch. I thought I could do it myself and not have to send it away, I hate sending stuff away when i could just do it myself. how would i solder it, i dont have anything to solder to and I dont want to melt all my wires and plugs and such.

-HellFish