Eclipse blade trigger question

[mafiagodfather4]

Ok, I ordered a black eclipse blade trigger from pbgear.com and when I got it the directions said "Magno-Blade Trigger" or something like that. It also came with a little screw-like thing with a magnet on it. I didn't order an magno blade. Did they send me one? And if they did then how the hell do i get it on? Cause I wanna try out how the magnet feels.

[ShockerGEEk]

Take out your trigger spring and thread the magnet part down the hole where your spring was. Then install the trigger as you normally would ie. removeing both trigger pin c-clips, then the pins. Now this is just a guess on the magno blade, casue i have never istalled one but I know the magnet replaces the spring.

[mipaint]

First, yes it would appear that you got a magno blade.

Second-- on MOST impulse frames, you can not use the magno blade unless you are willing and able to do some taping and most likly some drilling.

Simple way to tell if your frame will allow a "drop in" magno blade... Look at the bottom of the frame. If you trigger gaurd has a hole drilled thru it, the frame is all set for a magno blade. If you don't have a hole in the bottom of the frame, you will almost certanly have to at least do some taping (1/4-28 AKA 1/4 National Fine thread) and you will most likly have to do a bit of drilling (need a #3 drill)

FOM

[mafiagodfather4]

What part of the frame? At the bottom of the trigger guard? Where the spring goes, the hole goes the whole way down. Is that what you mean?