Terminator1
01-11-2003, 04:42 PM
Was at the field today, and the gun stopped firing, it was set on the vision mode, so I bring everything back to the house today, take the gun apart and clean everything up, even cleaned the vision eye thinking it had a piece of trash or something in it, I also changed the battery out in the gun to see if that would work, what happens is you turn the gun on by holding the rear button on for two seconds, it chirps, hit it again to set it in vision mode it blinks five time a sec, which shows me that the vision is on, so I fire one shot and the gun stops firing and the gun goes back into normal mode, thus cutting off the vision, sounds like a faulty vision?? Not sure, probably send it back to Epaintballoutlet Monday and let them figure it out, this gun has only three cases of paint through it?? Any suggestons? Has this happened to any other Vision owners??