Advise Needed

[automagman]

First i have a b2k2. And it chops like no other. i say i would chop 20 balls out of 1000. And the balls didnt break in my barrel cuz my bolt was pink after every game. I used fresh paint and a good paint to barrel match. Next if i tighten my ball dent to the point it accually works the bolt gets stuck. If i make it so it doesnt then balls roll out the barrel. And next should i get a 10 inch ultra light or a 16. They dont make 12 were im buyng it. Or is there a barrel that is better for like $50. And should i buy a warp feed or a halo b for my gun? I have a 12volt right now and i think im choping cuz of my hopper. Thanks.

[vapor_skank]

Do you only break balls during rapid fire? Then that would be your hopper. I have 12volt and it keeps up fine so i doubt it could be that. im probally gonna still get a evolution 2 though. What kind of paint are you using? Is your velocity too high? info needed..........

forgot about barrel ques.....i think cp has a decent barrel for $55. It got the best overall for price and performance in the barrel review on www.obdo.net

i dont have one but im planning on getting one.

[Crisis]

Originally posted by automagman
First i have a b2k2. And it chops like no other. i say i would chop 20 balls out of 1000. And the balls didnt break in my barrel cuz my bolt was pink after every game. I used fresh paint and a good paint to barrel match. Next if i tighten my ball dent to the point it accually works the bolt gets stuck. If i make it so it doesnt then balls roll out the barrel. And next should i get a 10 inch ultra light or a 16. They dont make 12 were im buyng it. Or is there a barrel that is better for like $50. And should i buy a warp feed or a halo b for my gun? I have a 12volt right now and i think im choping cuz of my hopper. Thanks.

if you tighten your ball detent to where it works and the bolt is getting stuck, your ball detent is stuck and it is bad, replace it.

Do you own another gun? if so is it different threads then the B2k ? more then likely... I bought a freak setup, cause I like it. you may not, BUT another barrel system might be good... gives you alot of options.

as for the gun, do you know what generation OR feednack you have? if you have a SHORT feedneck, consider a ICD mid or High rise, or a check it products high rise.. that helps with chopping!

[automagman]

I like to shoot low so and my pressure was at like 220. It was Gap. And yes i have another gun. But its automag threads.

[ShootPaint]

If you are having problems with the ball detent obviously replace that first.

Once you feel you have a good ball detent then look at the chopping issue.

If you still have balls rolling down the barrel you will not want a halo cause it will push them right apast the ball detent. You may way to look at a Egg. They are some where between a Revy and a Halo. They force the ball into the feed neck, but they dont push the ball down the feed tube. This might be a better option for you than the Halo.

I am tired so I will quite the rambling for tonight!

[automagman]

are ball dents universal. Meaning could i get a angel ball dent and make it fit my bushy? Or what site can i order one for cheap?

[ShootPaint]

A ball detent is no different that a barrel. Everyone has their own thread patern for there marker.

The bushy uses a cocker thread ball detent.