mr. lobster
01-23-2003, 02:53 PM
I was playing w/ my dwell since i just got a new cricket board... I noticed that when i turn it all the way up I could lower my input pressure... is this going to cost me big time in efficiency?
Also, what exactly adjusting the dwell doing? higher = valve open longer? but what does that do for me... same with lowering it.
For internal upgrades right now I just have a vff and voodoo bolt with a vert max flo. so the total weight is like 1177 grains or something. I might get a delring pull pin from a friend though, but this would put my weight way down.. could i compensate for this with dwell/pressure changes? or should i just wait and get a heavier hammer with it?
Also, what exactly adjusting the dwell doing? higher = valve open longer? but what does that do for me... same with lowering it.
For internal upgrades right now I just have a vff and voodoo bolt with a vert max flo. so the total weight is like 1177 grains or something. I might get a delring pull pin from a friend though, but this would put my weight way down.. could i compensate for this with dwell/pressure changes? or should i just wait and get a heavier hammer with it?