BKO went down!!!!!

[ccrnnr9]

I went to play with my BKO today and this is what happened:

I gassed up the BKO (crossfire 68/4500 n2 tank)
I tuned the pressure on the HPR to about 235-240psi and then proceeded to turn the LPR in until it started to leak a small amount of air. I then turned the LPR out about 1/2 turn, and started to play. I played one game and everything was fine, then in the second game, I chopped a ball, and cleaned the barrel and top chaber out. The next game I started to shoot, but the first ball came out fine, but the gun would only recock about 3/4 of the way! I pull the cocking pin back all the way and the ball goes in the chamber, then fire and it wont recock again! I have the tank all the way full the LPR and HPR are fine...what could be wrong?

[ayzian]

something might have gotten into the ram assembly because of the chop. You might want to open it up and check to see if anythings in the hammer area./

[ccrnnr9]

I am a true idiot now!...When I took the bolt out to clean the top chamber, I put the pin back in a little bit farther forward than it should have been...it works fine now!

[ayzian]

lol yea... you gotta make sure the bolt pin is put in the right place. hehe hope you like ur gun more now that you know how to put in the bolt right :-)

[SPS16]

awww that was the problem

[king]

Don't feel bad , that happens to the best of us!!!:D

[ayzian]

er not me......... :P

[SPS16]

Originally posted by ayzian
er not me......... :P
oh just wait

[ayzian]

lol

[F.O.D.]

i haven't gotten my bko yet, but how do you know when it's in the right spot?

[JTramoDude]

if its like a b2k (Which it shoudl be)... u look down the hole for the pin... and the hammer has a groove in it.. u just line it up with that... as soon as u look at it ull know.

[ayzian]

nah... it's the BKO. You should just place the pin and bolt all the way back. That's what I do.

[ccrnnr9]

Ya, I had the pin in the bolt, but since the pin has two notches, you just wanna make sure when you push the pin in, the bolt is not showing in the feed tube

[Ruben]

hey was wondering if you all can help me...i played sunday everything was fine...then i cleaned it up and gassed it up to dry fire it (to clean it) and it was leaking air it seemd as if the valve was leavking im gonna take the gun apart today and check everything but any advice..??

[JTramoDude]

turn town the regulators a bit... thats happens as a back-up when ur pressure is too high.