Gun not completely cocking at high ROF

[_Big_Mad_Dog_]

hey this isnt really a major problem im just wondering why the gun kind of uncocks when i shoot fast, it doesnt completely uncock, just not come all the way back to where its supposed to. ive got a rico so its not a ball feed problem

[Cadet2005]

Not entirely sure why, mine does it too with my RT, but if you run CO2 you might not be getting enough air in to cycle the bolt all the way back...since it is a gas operated cyclic system, it requires a certain amount of pressure and if after a while you are not getting that pressure it will basically go about two thirds of the way back and go "no".

[Ejp414]

Try tightening the screws on the right receiver half. Tighten them as much as you can for both.

Also like Cadet said, it might be a pressure problem. Check you hoses to make sure there isn't anything in them and check your pin valve to see if everything is working right.

[Turambar]

I think they all do that. I know mine does. As to why, I am not sure but I'm going to guess it is the same idea as shoot down. The recharge rate for the valve isn't fast enough to keep up with your shots so it isn't able to recock the marker fully. I may be wrong, I don't know.

[arson51]

its several factors. the rt is taking up valuable blow back force, you are using co2 adn co2 has drop off at high rof. and the valve is desinged to have a delay between shots, relatign to max rof. if you shoot faster than the delay the gas and valve wont recharge fast enough and it will just "machine gun". they only way to fix it is to recock. or buy nitro and a reg