New Desingz Equalizer bolt

[BeerPimp]

I am looking at buying an impulse. If I just upgrade the stock bolt to the ND Equalizer the weight of the internals will be 1143 grains. I was wondering if this will be too light. I read the internals page and it says you will have problems if it gets below 1100 so I figured is should be ok. I was also planning on installing and lpr. I am not sure how much of affect that will have on it.

[FOM]

If you thinking of getting an LPR-why not just START with an LPR-- like on a college pack (LPR and Blade trigger)

In answer to your question the "too light" issue will normaly cause you to have to use a bit more gas to get the same veloicity. If you are not planing to get a slick shaft- why not just pick up a brass Rathole hammer at the same time-- they are not expensive and buy buying at the same time you save on shipping. Ofcourse the HOT setup is the the ND bolt, slick shaft, SS rat hole hammer, and ND GMFV (valve)

[BeerPimp]

Thanks for replying so fast. I have looked at your website many times. I looked at the ratified kit and I am going to end up ordering that. Also I was searching for lpr information and it said it was better to mount the lpr on the VA rather than the valve cap. This way when you are shooting fast you don't starve the selenoid. I was wondering if you sell a ND LPR kit designed to install on the VA? This way you would get the 90* nipple and tourney lock all in one kit without the front valve cap adapter.

[cris8762]

AH!! i hate myself SO MUCH!!

everytime i order someting from EPBO they come out with the exact same thing cheaper!!

i ordered my impulse upgraded, a week later and they come out with the project rats for the same price as my gun but better!!

i buy new internals and a LPR (pretty much rat factory inernals except for the bolt ) and they come out with the ratified and rat factoy kits!!!! ARHG!!!!!!!!

oh well.....i still have a great impulse that rips up the field (wheni get it working:( )