adjusting the evil LPR

[Paintball9908]

I have the evil LPR and I was wantering how far should I screw it in, is their a good setting to use? Right noew it is all the way in, and I think it is so far up no air is going in and it is like having no LPR at all.

[DasBaldDog]

The Respirator, when fully maxxed on pressure, delivers somewhere around 250-300 psi.

Mine is only about 3 turns from the top.

[spedchild1]

If you can, install a gauge on the back of your gun, just under the hammer assembly. You want to try to get your max flo at around 200, and your bolt press(gauge on back of gun) around 110. This is what evil recommends. Dont go over 200 psi on ur OP, or you f*** up ur soleniod ;)

[Spec]

What u mean ur own OP??
My MaxFlow is on 150 Psi. now and i am wondering is that good with my Evil LPR or should i adjust it when i get my Evil LPR???

What is the best way to set ur Psi at??

[spedchild1]

OP=operation pressure, or for some, output pressure.

For the whole set up, go to www.actionvillage.com then go to the paintball section, then to gun uprades, impulse, then select the evil lpr, in this window, they have the whole setup...but for starters, the evil lpr, as stated from evil themselves, runs at a high 200psi on the maxflo, and around 110psi for bolt pressure, but every gun is diff. Ull need a chrono for this set up, fo shore.

[spedchild1]

correction, i got that last page wrong, sorry, heres the whole url.

http://stores.cipp.com/Merchant2/merchant.mv?Screen=PROD&Store_Code=mipaint&Product_Code=12306653001&Category_Code=lprs