co2 is best!

[blades of ice]

when i was at the aka site i was scaning thru and found this! look at this
http://www.akalmp.com/akalmp/akamain.htm

near best reported setups what heck is this about I might not buy nitro

[MuckRaker]

exactly what are we looking for?

[Predator2]

Yeah really i can't figure out where it is you are talking about.

[MuckRaker]

Althought I did like the picture of the guy hanging off the forklift.

[Predator2]

Yeah i found that a bit amusing too.

[TLplus84]

LOL i could do that...:D

[blades of ice]

whoops well follow the link and go to the spyder tornadoe valve installation spot and read damn computers never work right

[Counterfeit]

I still don't see what you want?
Yeah a tornado valve. what about it?

[blades of ice]

it says that co2 is best for spyders and spyder like guns

[blades of ice]

first click on the link then when loaded click on install intructions and click on spyder tornadoe and you should read that it says the co2 is best

[Auctionjunkie!]

Originally posted by MuckRaker

Althought I did like the picture of the guy hanging off the forklift.

That's Larry Alexander, one of the owners. They did that to prove how strong the threads are on their feed tubes. Larry's not a small boy....

Dan
Manager, Team Wiseguys

[Phaelon Veritas]

I think this is what he was talking about....
http://www.akalmp.com/akalmp/page/install.htm#2
.

BEST REPORTED SETUPS:
In order of performance preference
/=all in one category
,=next category

Nitrogen/Air - Use CO2 or Nitrogen/Compressed air (CO2 works best on the Spyder.)

Secondary regs - Vigilante by Air America/Palmer Stabilizer, Bud Orr In- line Reg with AKALMP Adjuster Cap, Uniregs

Bolts - AKALMP Lightning(tm) bolt, Bob Long Cyclone bolt.
If you want to use the AKALMP Beavertail/Cocking Rod, make sure the back of the bolt is tapped to 10-32.

Barrel - Javelin(tm)/Lapco or a 14" with a .687 bore or smaller.

AKALMP Mitey-Max(Pat pend)(tm) Air reservoir - Best used on all Spyders. Now available for the compact Spyders.

Springs - Stock Springs from the Spyder, do not cut them.

Inlet pressures into the marker - will range depending on velocity but at 300 fps the psi range should be about 280 psi to 300 psi. This also depends on marker setup, what type regulator you are using, and the paint used.

VERTICAL MOUNTS: If you have had the air hose replaced with a vertical mount it is a good idea to have an airsmith drill out the air passage hole in it to .187 to 203 for more air flow. This procedure is best done on a lathe.

He was saying about co2 being best for spyder with THIS PARTICULAR VALVE...


[Edited by Phaelon Veritas on 02-15-2001 at 09:50 AM]