Polished internals

[Predator2]

Does any one know how much i need to sand down my hammer and bolt to polish it. Im not sure if im supposed to take all of the anodize off or just make it smoother.

[Predator2]

ok i need some help so can you guys please answer?!?

[TLplus84]

i didn't polish my striker, i only polished the part where the sear touches the striker..

[Predator2]

can you polish the bolt too?

[Auctionjunkie!]

Basically polish all the moving parts and the surfaces they contact. Don't remove the anodizing just make it as slick as possible. In the case of a Tippmann 98 remove all the overspray on the inside of the gun. Use a very light sand paper, 1200-1600 grit and then use a good polishing compound.
You may want to polish all the air paths as well. This decreases any resistance that the air may have in going through your gun.

Dan
Manager, Team Wiseguys

[Predator2]

do you have any suggestions for a spyder or are the spyder and tippmans pretty much the same.

[A damn fool]

i just smoothed them a little bt with 600 grain sandpaper, and that was it. I didnt take any anadozing ff, just smooth them a little, and polished them with the stuff, and it made them extremeley smooth.