PDA

View Full Version : Frame?

dawg
04-22-2003, 11:52 AM
Anyone have a 2.2 BBT frame they want to get rid of? ;)
lmk
-Joe
Vaypourus
04-23-2003, 02:55 PM
Good luck...these are very hard to come by ( I know...I tried unsucessfully for a long time!)
dawg
04-23-2003, 04:02 PM
Hoped it wouldn't be hard.. :( ah well, I'll see if I can convert any other gun's frames (angel, possibly?) to a tribals.. might be kinda fun?
Vaypourus
04-23-2003, 04:07 PM
You can, but you need a tub to house the solenoid. They add height to the gun, and are kind of ugly.
dawg
04-23-2003, 04:10 PM
you tried? is it possible to make a tub, or..?


should we start a new thread?
Vaypourus
04-23-2003, 04:13 PM
Rich @ Fear Factory paintball used to make the tubs for the conversion. You probably want to speak with him about doing it if you are really interested.
dawg
04-23-2003, 04:21 PM
Thanks Vayp! I'll message him to ask... this should prove interesting!
Paint Bulley
04-30-2003, 10:25 AM
you find anything?
dawg
04-30-2003, 05:30 PM
The site is down, so I can't get a quote at this moment.. but It's $30 for just a tub, or else send an Angel frame and $30, and he'll connect them for you? I'll quote it when his site comes back up.

-Joe
jakesak
05-01-2003, 03:35 AM
I would get in contact before sending it out. He said he was not taking any new work until he gets everything back in order (unless pre approved:D like me). Or you could just get ME262 to do a sickle on your current frame. I have pics of it you would like to see.
daveofdoom
05-01-2003, 02:14 PM
im not sure if i would send any thing to him now i have been waiting for him to send my gun back for almost 2 mounths now.
Vaypourus
05-03-2003, 12:08 AM
Originally posted by daveofdoom
im not sure if i would send any thing to him now i have been waiting for him to send my gun back for almost 2 mounths now.

You and a few other guys.

Its amazing how much stuff gets lost in the mail in route to Rich or on the way back...

Rich did some work for me a while ago; he didn't re-annodize the part like he said and he over machined the drop, which caused the screws stripped out. Can't say I am too impressed.