sck
04-23-2003, 02:31 PM
...on installing a ND valve?
I printed out Wolverines detailed instructions and know exactly what has to be done. While it seems simple enough, I've been told by many people that changing out the valve can be a real pain in the ***.
Are there any recommendations people can make from their experience replacing their valve? Any tool/method that made the process easier? Anything at all?
Thanks.
Oh, and when I loctite my new hammer to the ram, do I loctite the thread (if so, how much), or just seal the two pieces once connected? (I would assume I would do up the thread, but it never hurts to ask.)
I printed out Wolverines detailed instructions and know exactly what has to be done. While it seems simple enough, I've been told by many people that changing out the valve can be a real pain in the ***.
Are there any recommendations people can make from their experience replacing their valve? Any tool/method that made the process easier? Anything at all?
Thanks.
Oh, and when I loctite my new hammer to the ram, do I loctite the thread (if so, how much), or just seal the two pieces once connected? (I would assume I would do up the thread, but it never hurts to ask.)