Max Flow Vertical Reg

[Jaymz]

Ive posted in both Smart Parts forums and havent gotten a single reply and this is really important. So im getting a shocker prolly tomarrow in the mail with a vert max-flow, sense shockers need to be at 180 psi, I beleive its anything above 300 will blow out the noids, I need to be sure the reg is set very low before I gas up the gun. How do I adjust it? I only could find directions for the horizontal max-flow

[-=ReD-hAzE=-]

i don't think they send them too you with the reg's set at 600psi...:rolleyes:

i'm pretty sure its gonna be fine...

[NYRChaoS]

well if you bought the reg separate it should be at 0psi

[Mcot2]

ok

1.) Max flo, adjusted by screwing or unscrewing the endcap. In is up, out is down.

2.) Max flo regs on shockers cant be set above 240psi, therefore they can never blow the noids.

Now stop spamming the shocker forum.

[cocker kid 2k2]

There will be a cap on the end of the Maxflow regulator, screw it down completly, but not till it falls off. It'll be at around 0 psi. Then screw it up gradually to inrease the pressure. And your solenoids will blow at 230 psi.

[Jaymz]

so do I just stop screwing it in when my fps is right or is there a guage that tells me? I know nothing about shockers/max-flows

[cocker kid 2k2]

Stop screwing it in when you reach 280fps.

[Jaymz]

ok

[Mcot2]

Originally posted by cocker kid 2k2
There will be a cap on the end of the Maxflow regulator, screw it down completly, but not till it falls off. It'll be at around 0 psi. Then screw it up gradually to inrease the pressure. And your solenoids will blow at 230 psi.

The selinoids on shockers dont blow at 230psi, thats bs.

They will however blow at about 250psi, and the max flo vents at 240psi, therefore it cant blow.