Whats is the Best Squeege for a Flatline?

[zack1126]

First of all I really like my flatline. When set at a velocity of 275 it works great. At about every 1,000, I'll break a ball.

The big problem is when that happens.......what is the best squeegee to use in cleaning it and what is the best way to clean it while playing?

I am a dead man if I try and disassemble the barrel and clean it as tippmann suggests while playing. I have heard of opening the feed elbow and running a wire squeegee thru there and pull out from the top. Not sure if this is the best solution. Any suggestions would be much appreciated! Thanks.

[p8intballpunk00]

i say get either a battle swab or get a long stick squeege preferiable 14 inches

[Aglar]

The flatline bends, though. You can't use a jerk squeegee. Going the pull through route is your only option, AFAIK.

[snipers002]

yea youd have to use a pull thru. jsut get a long one with lots of disk and swab.

[lucky7]

I would get a pull through with only disks and no swab because the stiff wire that makes up the swab may be difficult to fit through the elbow.

I have one of those cheap 5 disk squegees that you can get for 6 bucks and I pulled it through the standard feed port and out the barrel of a talon that needed cleaning. So it will most assuredly fit through a tippy 98 elbow, as long as the wire is long enough.