My Flatline Cocker fires two balls!

[Viper72924]

[FONT=arial][COLOR=blue] My Flatline AutoCocker shoots two balls sometimes. When I pull the trigger the bolt will come back and a ball will go into the chamber, but the when i let go of the trigger the bolt closes and nothing happens then il pull it again then another ball will enter and two will fire out and curve off and fall short. Sometimes it does three but most of the time it does two balls. I think it's the bolt but I really dont know. I need your help.

[macdruen]

Sounds like the hammer and sear are not engaging so the bolt ccycles but the hammer just goes back to fired postition. tighten the cocking rod and also the knob into the back and see if it helps.
if not it could be
1) length on pushrod needs to be just a smidge longer.
2) internal prob with sear or hammer
3)ask an expert:eyes:

[macdruen]

Wife just said something really obvious it could be the front reg pressure is a bit too low or is backing off and so it is not pushing the ram far enough to engage the sear every time.

[krasher]

Also, degas the gun, cock it by hand, and check if the bolt clears the breach. When degassed and cocked the bolt should be 1mm back into the body.

If that's fine, then its the timing.

[D-RoK]

I would check the sear. If its not the sear maybe the cocking rod is too long.

[paintballer56]

when i had my flatline on my tipp98, it shot two balls sometimes, never figured that out yet

[CARBON]

god, thats the reason I wouldnt get an autococker, their 2 complicated for me.

[paintballer56]

then why are u in worrgame products, go back to your simple low end forums, pish

[DRAGSTER420]

hehe thats funny.......but very true

[Magadeth]

How is the ball detent set up for the flatline cocker?


Oops, misread the original post, nevermind

[paintballer56]

wouldnt it be the same as a regular cocker

[w00twoot]

it is the same as teh normall cockers i thought it would be wire like free flow but i guess i was wrong

[krasher]

Its not the ball detent if it isn't firing.

[Silent Knight]

Originally posted by CARBON
god, thats the reason I wouldnt get an autococker, their 2 complicated for me.

why you here then.

1st check your cocking rod, and make sure it's screwed in all the way. Sometimes mine gets loose, and it'll keep feeding paint in the barrel, but not fire.

either that or it would be a sear problem.

[paintballer56]

or it might be the flatline drawbacks my flatline on my m98 did that also

[AR55 MtM]

maybe its a trigger bounce :confused:

[amzng_spyderman]

Originally posted by AR55 MtM
maybe its a trigger bounce :confused:
it's been 3 years since he posted this, i hope to god that he's figured it out by now...