pressure

[p8ntbllplyr00]

ok. this thread is for me to ask what the pressure(solinoid and maxflo out put) and dwell should be at if i have the following:
voodoo bolt
rip valve
HVFC
jackhammerII lpr(i routed this through the brass releif valve on the front of my vert max flo, i dont think i need the valve bc i wont ever get close to 200 psi)
slick shot
rat hole hammer

i really dont know what settings i should use but if any one could tell me that would be great. right now i have it on 140 maxflo output, and my dwell at 11 clicks from the bottom. i dont know what my solinoid is set at but i think its good. i have no shoot down either.

Thanks for the help everyone!

[CockerKid09]

Yes you do need the Brass Relief valve on your imp cuz if it happens to get ova 200 itll blow your niod and that wont be good so just put it in back by the on/off button.

[lilbmxer]

relief valve = life saver when you do something stupid by accident.....and you probly will one of these times.

[impyguy69]

Here ya go, set your lpr to max output pressure (screw it all the way in) and set yur max flow to 150. When it is at this, adjust yur dwell so you are shooting around 300 fps. Now turn your max flow to 200 psi and then adjust your lpr to shoot at the desired fps.