Low Pressure Kit Help!!

[cnastro]

Hey guys. I bought a LP kit and just got it in the mail today. I was assembling it normally when I ran into a little problem. I have to get the old hose off of the tank adapter so I can fit the new hose in there. However the old hose seems to be screwed in the tank adapter pretty good and I can't get it to unscrew at all. I've tried to soften the loctite with some rubbing alcohol but have had no luck. Any help would be greatly appreciated. Thanks!

[1Speed]

Here's exactly what I did to get mine out because I had the same problem. Clamp the ASA in a vice(either a vice with rubber padding or wrap the ASA in a towel or somethin so as to not damage it at all). Get a 7/16 crescent wrench and hold it on the the place it goes to turn the hose and at the same time heat up the area with a torch or a lighter. As it heats up, apply some pressure and the hose should easily come loose.

[legendaryloser]

Get a blow dryer and heat the area where the hose is screwed into the asa. Get a towel, wrap it around the asa and use a crescent wrench to remove the hose.

[cnastro]

Thanks guys. I used a blowdryer it was alot easier to get my hands on then a torch. :D