Wermstick trigger

[ds613]

Is the wermstick trigger a good upgrade?

[pr0kch0p]

yeah, i have heard that they are the best upgrade you can get for your imp (other than the vision and the freak kit)

[bbqchicken8]

yeah it's a great upgrade, it removes the slop from the stock trigger and it's fully adjustable. mine is pretty short. it ups the rof that's possible w/ ur fingers.

[Killer Kat]

I don't have one (YET!) But I will! I played 2 sundays ago with WERM and asked about his stick (the trigger! you silly's) It's sweet and does allow you to tap two fingers (like drum sticks) maybe even three if they're small enuff very quickly and make the marker sing and your victim sting!

[ds613]

Ok, I'm getting one! But, could someone please tell me how to get the c-clips off the trigger pins without damaging them.

[bbqchicken8]

i use needle nose pliers

[ds613]

This may sound stupid, but how do you use them?

[bbqchicken8]

the open part of the c-clip, you push those to ends off w/ the needle nose pliers, but be careful not to fling em across

[ds613]

Thanks:cool:

[FiRe ImPuLsE]

i ordered a genesis board from wermmods, and bill(werm) threw in a free wermstick for my impulse. he said its easy to install, but does anyone have exact directions? or can give me a step by step guide to installing it? also, how do i adjust the trigger to the shortest possible setting, without going too far? thanx guys

greg:confused: :)

[bbqchicken8]

fire impulse, how'd you order from him? did you call on the phone. that's cool that he included a free wermstick. does he also have the genesis vision available?


to install the trigger you have to remove the old trigger by taking off the c-clips then removing the two silver pins. but remember that the pin with the skinny middle section goes in the slot in the rear. then remove the trigger frame and put in the new trigger. the black screw that is in the trigger should be removed. the other two are for fine tuning. after you get it in you need to fine tune it to your liking. sorry that i'm not to specific but it's late and i'm dead to the world. if you have more questoins just ask.

[pr0kch0p]

on the genesis vision site, i think i read that doc from doc's machine installs them, well they said that it will be installed by doc, so i assume it is doc from doc's machine . . .

[bbqchicken8]

i'm interested in installing the GV by myself cause Doc will take about 4 weeks to do it. =(

[FiRe ImPuLsE]

well i was wondering how u take out the clips and stuff? also how do u isntall the spring again? i ordered from the website i didnt call . i want to adjus the trigger to the shortest possible setting for say to tap the trigger

[wolverine]

Originally posted by bbqchicken8
i'm interested in installing the GV by myself cause Doc will take about 4 weeks to do it. =(

So you plan on milling and threading a hole in the side of your Impulse for the Genesis Vision ACE? Good luck!!

[bbqchicken8]

milling is fun=) . i've got the equipment ( my dad owns a grinder factory =) ) i'm just wondering if they supply instructions

[Nemessis]

Heh, Crappy c clips I lose them like crazy, now I use black e clips since the look better.*





















*Only thing canadian tire had