Bushmaster help

[Rodman]

I can't get the velocity on my bushmaster over 200fps even with both regs at the factory settings I have an air america armeggeddon tank on it and its set to 300psi tried new battery w\h no change could the hammer spring be worn out?

[ShootPaint]

Turn your Geddon up to about 400psi.
Some B2K's will run around 250-300psi. You may be starving your main reg and not allowing enough gas through the marker to propel the ball properly.

[ayzian]

In fact, you might even want to set your tank to 500 PSI.

It's been recommended that at least 200 PSI more pressure should be going into the HPR.

If not, you will be starving your marker and you will get shoot down.

[PRORAPTOR]

my preset is at 800 PSI! lol....Works awesome!
________
buy extreme vaporizer (http://vaporizers.net/extreme-vaporizer)

[Rodman]

I went and played yesterday and finally turned the pressure up to about 850 and still no change in the velocity and after refilling the tank the marker would shoot twice then take about 15 seconds to recharge so i switch to a high pressure crossfire tank with no change it either problem. I know the tank works since I used it on my angel and my shocker with no prob. Thanks for the suggestions though (I'll try again today) and if you have any more keep em coming.