Want to get you cocker body milled?

[CHRIS]

I am doing milling to autococker bodys on the weekends for a bit. I can do cuts,groves,fishbones,holes,slots,take off anything ect.
Prices are from $20 on up depending on how long it takes.Last time i put this up eveybody wanted to see pics to here are some and more to come. The chrome gun is mine and if you get this done you will be buged and asked were did you get this done or your money back.(just joken)

[VeNoM]

can you only do cockers? that looks nice, is that something YOU did or just a pic of some milling? nice job :D

[CHRIS]

No no that is my gun that I milled.Well what are you wanten to mill.I havent done anything else but tell me what you got.

[CHRIS]

AHH I SEE A BUSH MASTER.I am not to familiar with the internals,

[frenchtoastdude]

I like the milling! How much for the milling you got? How long will it take? Could you do the one picture below?

[CHRIS]

Well what you see there is what they call ripped milling.I was going to send my gun out to get dune but i think it was like $290 bucks, I was like no way.So no i can't do that.But if you like what my gun looks like i would charge $100.I would pay the shipping back to you.

What i did to mine is take off both site rails.
Cut close groves on the bottom tube.
Deep groves on the top tube to see bolt.
It looks really cool on top when you see the groves coming into the site rail and your blot going in and out. It takes me about a weekend and I ship it back that monday.

[paintballer56]

i might be interested in the future, ill get back to you

[frenchtoastdude]

I know its ripper milling. Can you anodize the gun too?

[CHRIS]

The only thing i am doing is milling.You can always send your gun to pk selective.They do really good anodizing.