Uh-oh What Did I Do?!?!

[Woozer]

I took the board off of my impulse, and now, when i put it back on, the trigger wont activate the micro switch! Like sometimes it will, and then I'll put it all back together, then it'll stop working again....Waht the heck did I do? I'm really confused and starting to get pissed. Can anyone five me any tips to fix this? Like i adjust the micro switch, and then it just goes back to not working, it's a real pain, so any help is good. Thanks.

-Joe

[DynastyKiD69]

you might of bent the little alluminum(i believe) thing that activates the switch just make sure you didnt do that and it should be all good man

[Woozer]

I think that might have been what happend, so i just bent it a little in the opposite way that it was bent, and it seems to be working fine now, thanks a lot, so simple, yet I never even thought about it, lol.

[imppimp]

if you have a blade trigger the length screw could be too high which wouldn't give it enough room to recock the switch