please help!

[smoke37]

I have been having some trigger issues with my new bushy and the manual leaves a bit to be desired...
the trigger is slightly loose, if I point the marker upward the trigger moves slightly. also the LED light doesnt blink when I shoot
like the subject says- please help!:(

[PRORAPTOR]

Sounds like you need to adjust the actuating screw in the trigger

[smoke37]

I tried that... seemed to have no effect

[PRORAPTOR]

If the light stays on and doesnt blick its either your actuating screw or a bad switch.....

[smoke37]

and how would I fix this

[shtson]

If its the screw unscrew it(counter clockwise) if its a bad switch u have to order a new one
either from ICD or Vapor Works or Tantrum

[smoke37]

so unscrew the top screw all the way then just put it back in?

[shtson]

Well if it has three screws like my 2k3 BKO then the top would do it, here is what u do.....
Take the screw all the way out so that when you pull the trigger if doesn't even touch the microswitch, then screw it in a little everytime and each time pull the trigger and see if the led goes on,off,on....if it is on then goes off and stays off when u pull the trigger you have it in too much also if you made it so the top screw was in too far you probally broker your microswitch.

[smoke37]

I got help from the local tech. thanks for all the help guys.