Help!!

[angclassic]

I seriously need to know weather to get a low or high pressure tank for my impulse. I don't know if this helps you at all but I'm getting a tape worm and maybe a LPR kit.

I want the gun to run as air effeciant as possible. I heard low pressure was better but I not sure.

[Dr J]

If you have Max-Flow reg on your Imp, it doesn't matter a whole lot.

You may recieve a slightly faster recharge rate from the lower pressure output tank (i assume aroung 450 psi) than you would from a high pressure output tank (about 850 psi).

Also at the very end of the tank full of air, you may get a slight bit of difference in the last 400 psi out of the higher out put tank

But..... in the end you probably won't notice a difference. I have a hard time (and sometimes don't) and I am very particular to the tunings of markers, especially Impulses.

My two cents.... since you won't notice the difference between the two setups, buy the cheaper one. Or buy the high pressure tank cause you really can't use the low pressure output on as many guns, so resale/reuse value may not be as high.

[LordOfThePaint]

get a HP tank, your regulator will bring the pressure down for you gun. If you plan to get an LPR right away then dont get a tapework, because you can only use one at a time.