Autococker velocity adjuster

[magicsly1]

The velocity adjuster keeps on backing out and lowering my velocity. Do i need a new o-ring or what????:confused: :confused: :confused:

[bigbobmegadeth]

mine too, i dont want to use loctite because I will have to reaply it when i adjust my velocity. after 2 games my velocity went from 295 to 150. i was holding my gun a like a 45 degree angle to hit the guy 2 bunkers in fron of me:atten:

[Silent Knight]

hey magic, try putting some teflon tape on your IVG. I did that to a few guns that had that problem worked fine. just make sure you dont over lap it so much that it'll impede movment of the main spring. should work though

[bigbobmegadeth]

nope not teflon tape, i put a tank o-ring in place of the old one that was on there an it fixed it perfectly. the teflon tape just wears right off

[bigbobmegadeth]

sorry, i mean put a tank o-ring on the IVG. it is a little tight but it works

[Silent Knight]

teflon tape works dude, i've done it many times. works better if you have a slightly off threads on the body, where the IVG is very loose. But hey if the o-ring works for you, more power to you!!!:tup:

[bigbobmegadeth]

yea, normaly i dont like to use teflon tape on anything buy like bottom line fittings and stuff because it seams to wear off and get in places it shouldnt be, just my personal experience.

[Geppy_41]

The trick I used was to put the Blue Loctite on then LET it DRY. You'll need a wrench to take it off the first time. I haven't had a problem since.

[bigbobmegadeth]

i have the blue loctite but i didnt want to use it because it seems to wear out after a few adjustments