Clueless on upgrades

[misterj0shua]

Im looking at upgrading my 2k2. I have been looking at several upgrades and what not. I have a few questions and mabe someone can help me. First, what is an ASA. Next, when I go to upgrade should i updrage both my LPR and HPR. If i do upgrade my LPR where do I install the valve at (or am i all wrong). I've been looking and reserching my gun for a while now. And since I bought it off a freind I dont have much to go on. Heres what I was thinking of getting, and someone could take the time to tell me what else im going to need to add in order to install that, I would really apprecite it.

Sonic LPR kit, Vapor Valve, 2k3 gladiator inline reg or Centerflag hyper inline reg, Tantrum Bolt, Vapor Works Chaos...i cant think of anything else right now I got 3 girls talking really fast around me and cant think.

Well I may or may not know what im doing....so if i dont PLEASE HELP!!!!!!! :confused: Also whats a FMD Autococker LPR Adapter or a BKO ASA for Autococker LPR Set UP. Also who ever took the time to read this and is reponding.....thankyou very much

Barber

[flamingbanana]

Hey...I had the same questions when I was starting out, so here it goes.

I would recommend getting a zenitram BKO front block with porting for the microrock. Then, obviously, get a microrock and a barb kit. Doing this eliminates the stock LPR and replaces it with the palmers. I originally had some problems with my LPR so I simply switched the front block and that fixed everything. As for your original question about the LPR, the small one between your HPR and your trigger is eliminated. The new block, instead, adds holes in the front of it for a autococker aftermarket LPR.

If you are going to get a high-flowing valve, i would reccomend getting a mitey max from AKA or a similar expandend volumizer, this, coupled with a new valve, will increase your gas efficiantcy quite a bit.

Unless you have blow back, which you can see by setting a piece of toilet paper over the vert feed and firing and seeing if it blows off, then a new bolt is pretty pointless. The stock bolt is already drilled pretty wide, so it is most likely as good as any other aftermarket bolt.

The same goes for the HPR. Try the gun, and you can see if you think you really need a new HPR. THey are pretty costly, and most of the time, you won't notice a big difference. I would rather spend the money on a barrel kit with adjustable bore sizes.

The chaos chip is also just personal preference. If you have the new BKO, and I think that you said you did, then it will already allow a very high ROF if you can walk your fingers that good. So the chaos chip is really just for show. I would recommend instead getting an agitated hopper, if you dont already have one)


Hope this helps out!
Lawton
~*Team Naners*~

EDIT : I just noticed you had a bushmaster...in that case, you just need a hoseless palmer adapter for bushmaster, rather than changing out the whole front block.

[misterj0shua]

How would the hoseless adapter go into the LPR....what exactly would i need to take out. I do have the tech readout on the bushy, but i can only go as far as to take out the piston. Also would the sonic LPR kit work...