Sniper tigershark

[Combatcm]

I sawed out a bit of the front of a tigershark frame to fit a stingray thunderpig barrel into it. It shoots pretty good. I'll just post pics to give people ideas. On the 2nd picture its not all the way in, its just showing how it fits.

Heres a link to all the stuff

http://community.webshots.com/album/92309475jKNQjg

[Housemaster]

You can't link pics off of your hard drive. Upload them.

[Magnus55]

Hey that's pretty interesting! How does the singray barrel actually mount on the tigershark? Is it the same two pin holding system or did you do something different?

[Combatcm]

By itself its pretty snug. I use one of those metal screw clamps that fits around pipes, you put it around over the top of the barrel and under the frame, then tighten it up.

[sosoDAF]

sorry bout the whole sniper thing earlier.
I was in a bad mood.
thats a pretty cool mod you did.
Is there a way to make a stingray threaded?
Like to spyder threads?
Sorry Combatcm.

[sdlm]

hey, I got a tigershark too, I need a new power tube but, I will find one sometime I am sure, I was thinking of trying to put some autococker parts to make a pnematic assit tigershark, I know I've seen semi converstions but never a pnematic assit for a BE I have seen WGP snipers and CCI Phantoms that way but, never a BE. for those that don't know what pnematic assist actions are, you actuate the 3-way using the pump instead of a trigger, so instead of a semi you have a few milimetres of a pump stroke and that is it, making a pump that can make 6BPS or so, unless you got an autotrigger, then you can get about 8 bps, scary right? I just can't figure out where to mount the external parts (LPR,3way,etc) any suggestions? it doesn't have to look pretty.

[ChrisZ]

what Kind of barrel is that it looks pretty nice.