new bolt suggestions

[BRYCEBOY18]

I am thinking about getting a new bolt for my shutter does anyone have any suggestions on any bolts and how well they work????????:agree:

[Killer Kat]

There's only one choice IMVHO, and that would be a Tarantula's Delrin Bolt! check'em out and I think you'll be quite happy! pm Weasel00 and ask him how he likes his too! There are alot of advantages to going with delrin, like no lubin and less wear, as well as makein the marker alittle bit quietier too! I tried three others before I finally got my delrin bolts from the Tarantula here is his site www.Tarantulamfg.com You're gonna love them I'm sure! :love:

[djturmoil]

Check out the Bob Long Force 3 cyclone bolts
There extremely nice

[DraXsuS]

or if your low on cash, remove the venturi in the bolt,

[Imp_2976]

I have to agree with KK on this one...I had a Tarantula bolt in my spyder and loved it. Not to mention the guy who makes them is very cool as well...

[ThaFiend]

dude F that, get the Shocktech quickstrip venturi bolt. It has the delrin system AND you can remove it and put in in through the back wihtout having to take apart the gun, it's seriously the best bolt for sypders.

[BRYCEBOY18]

Will the shocktech work with the shutter's quick disconnect pin????:agree: :agree: :agree: :agree:

[Hsuve]

No, which makes it useless. I'd much rather have a WW teflon delrin bolt, very smooth. ;) I also wouldn't get a Shocktech bolt, because there's still the venturi design, and it's more expensive than the Tarantula, I think...

[Spyder^Man3k]

See what I dont like about forums, everyone has a different opinion for whats best. Best for what? Best for them? The only way to tell if something is good, is if you like it personally. O well, the forums are better than nuthin.

[Avatar]

hey why take out the little star thing in the stock bolt? would that cause any problems?

[big ugly spyder]

no actually it makes it in a snese like a lightning bolt, open faced bolt means higher flow and lower pressure

[Avatar]

but if i did that would there be any negative affects to my marker? could it be reversed?

[Moose]

Will the WW Delrin bolt work for an LP setup? And where can I get one?

[Hsuve]

Yes, it will work. You can get it from White Wolf. :D

[Killer Kat]

I'm sure that Tarantula also has LP Delrin bolts as well. I know he's a part of Werm's operations (maker of Shocker and Impulse Delrin Bolts @ www.wermmods.com ) who is big into low pressure markers!

[Paint Bulley]

single large hole, three hole pyramid, six hole circular, or seven hole (six hole circular with center hole). They are available with or without o-rings. For an additional charge you may order your bolt tapped and heli-coiled to accept a rear cocking rod.


what do I get?

what stuff?

I was thinking large hole, with 3 o-rings.

If I don't get it tapped, will there still be a hole, so I can tap it myself?

THanks,

[FireViper]

I'd like to know what each hole pattern does as far as performance goes. How doe each pattern differe from the other.

[BlindSeaman]

I'm just wondering why you would want o-rings on a delrin bolt? One of the advantages to delrin that you don't have to oil it.

[Paint Bulley]

Blindseaman

dude I totally forgot about that thanks!