kapp complete front end

[chynzexguy]

hey my friend was wondering if this would be a good front end to run low pressure on?

[Byte]

Yeah it would be good to run on a low pressure gun, but doesnt make your gun LP. Thats the main valve, valve chamber volume, springs/hammer, and main bolt. Your front pnues has littel to do with it. They just pump the back block and already operate at a scant 70-90 psi. They can be "tuned" lower however. A quality LP operation pnue reg and a smooth operating ram can reduce the psi needed to pump the back block a little. Again, main bolt "drag" tension of valve main spring are a big factor.

[chynzexguy]

thanks that's all i needed to know