Beyond a 2K1 Cocker

[pbn413]

I'm planning way ahead and I'm trying to decide what gun to get after I get my 2K1 cocker. Right now I'm thinkin about either a 32 degrees cocker or an STO, but know there are tons of cockers out there that don't get much attention. So instead of spending all my afternoons lookin, I've decided to let you guys just tell me what I should get. Again I'll be upgrading from a 2K1 cocker so if you've got anything suggestions under eight hundred dollars I'd love to hear them. We'll talk about over eight hundred once I upgrade from what we're discussing now. Thanks guys.

[frenchtoastdude]

The kapp autococker is good (so I've heard)

[AllOleander]

Cold Fusions are nice and dont get much attention..especially on the boards..

Pity, they are very pleasing to the eye and i woudln't mind seeing some in the picture thread. :(

[RavE]

Free flow cockers are the best!!!

[SEPHIROTH_086]

Meteor cocker, blade cocker, black magic cocker are all kick ***** cockers!!

[pbn413]

What's a meteor or blade cocker? I've never heard of them. Who makes 'em?

[Saiyan_warrior]

I've never heard of a meteor cocker, but Eclipse makes the blade cockers. I like the KAPP autocockers and Free flows. How much do you wanna spend?

[Moose]

Shocktech SFL cockers are AWESOME

I also really like the cold fusions

[Byte]

I really dig the K2 Flame, but the Spanky cockers are great too.

The long-awaited KAPP Flame Cocker is finally here! Each gun is hand built and tuned by pro gun techs Brian Duffy and Mitch Heinrich. The preliminary configuration is listed below. Please note that this list may change slightly due to demand and availability of parts. The anodizing of the raised flames on this gun is truly incredible and must be seen up close to be fully appreciated. There's nothing else like it.

Initial Configuration:
Chrome Clippard Ram - KAPP Rhino Reg - KAPP 3-way (chrome) - 15° Vertical ASA - KAPP 45 Frame - KAPP k2 Comp 45 Polished s/s Trigger - KAPP Comp 45 Sear - Lightened sear and trigger springs - Chrome twisted cocking rod - f/x beavertail - KAPP Venturi bolt - KAPP Pull Pin and Plunger - KAPP Low Rise & High Rise - Matching 14 inch DYE Boomstick (now standard) - KAPP Milled Front Gas Block - Chrome Ball Detent - KAPP 1/4x28 Hammer Kit w/ lightened springs - KAPP exhaust valve with seal and stem - 2-tone relief flame milling


Pics can be found at KAPP (http://www.kickasspaintball.com)