Possible full auto for cheap?

[BattleHazard]

ok, i was thinking and i came up with a new idea, i think. what would happen if you made a sliding bolt thing above the part of the trigger that pushes the sear, and made it extend to wear the sear would not catch anymore? ill post a pic in a minute of what im thinking of.

[BattleHazard]

ok, so if i put a very thin but wide strip of aluminum where the red line is, would that make it so the sear would not be able to catch because of the aluminum strip casuing it to be more level than without it?

[Raptorz922]

Won't work. First of all, it would open up from the instant you put CO2 in and cocked it and it wouldn't stop. Second, you'd chop balls like no other and I don't think any hopper would feed fast enough. It's pointless.

[E r y k]

no its very simple actually

you see the sear? theres like a place where the pin goes ? but theres extra room? fill in that extra room and as long as you hold the trigger down, you will have full auto

and chop alot of paint.

[BattleHazard]

well i guess the theory would work then, yay for me, but it would chop alot of paint, oh well:)

[Speedballer109]

Tried it.....bahahahah, bad idea, i called it the "BLENDER" :laugh: , good idea but not good idea...:sleep:

[llSmithll]

i tried that once. however, i took the sear out.

i covered the front of my own hopper with yellow fill.

[BattleHazard]

yep, its a blinder.

i put electro tape on the pin that the sear rest on, too much, and it was awesome, in sound not performance.



PAINT EVERYWHERE BUT WHERE I WANTED IT TO GO, LOL


this was a bad idea

[Villhime98c]

I tried that a while back, the bolt rotates so fast balls can't even enter the breach. I experimented and took a vaccum, put it in reverse, and attached the hose to the feedneck. It spit out all the balls without breakage put the accuracy was horrible.