omen + Z board = iffy...

[radishboy]

in the time i've had my Z board, i've had about 3 balls wedge behind the CAM feed arm. yes, it takes about 1/2 of a second to fix, but it Can be a pain when your in the middle of a game. im not sure if this is because of the z board or not, but it never happened with a y board. 3 balls out of about 2 cases isn't that big of a deal really, but if it keeps happening it could be a problem. could be the paint, i'll try some more later.

[Spartan 2]

Ummm...well I have not had this happend yet.

[kangaroodent]

It's probably cause the Z-Board pushes the balls down harder... You are talking about the Eggo2 Z board, right? If so, that's definitely the reason. The Cam Feed doesn't like force fed loaders much.

[ShadowWalker]

thanks chief, this was pretty much dead. look at dates on posts before you respond.

[kangaroodent]

Oops, I'm used to small forums where you can post on basically anything anytime, so what do you think a good time period is for the post to still be active? Thanks.

[PB0900]

I say anything on the first page is fair game.

[ShadowWalker]

well the cam feed is fine with an egg because there isn't constant pressure on the ball stack. even with the z-board, it still isn't putting constant pressure. not to mention the z-board ramps up to its higher speeds, where-as most y-board owners turn their boards all the way up before they even get them out of the box. they work fine with the y-board so there shouldn't be a problem.

anyways, 15 days with 2 replies...let it die.