Dragunfly Mech problems

[slicknck2007]

I boought my dragunfly mech about 3 days ago and when i got it i screwed my nitro into the gun and it leaked out of my macroline...well that seemed to stop but now it is leaking out of my low pressure 3 way system on the front where that screw moves in and out if u look in the little hole....well wutever that thing is called that moves when u pull the trigger (trigger trim bar thing) well I have to keep my index finger on that when i shoot or else the air comes out of the 3 way....is there anything i can do to keep that trim or wutever it is, pushed in adn stay in????

[chadlytle]

email dragun and they should replace it for you. Or just buy new 3 way o-rings. Hope this helps

[paintintexan]

check the the little clear gommet on the actuating rod (the rod that goes to the 3-way) it needs to be in the hole that it goes into on the grip frame above the trigger. I had the same problem about two days ago until figured out that it needs to be in that hole. If you got anymore questions just email me at sixshootertexan@msn.com. I hope it works out for you.