Gas Through Front Grip

[Soyboy]

I want to get a Minimag and would i have to run a bottomlin from the dropfoward tank to the front grip and then another bottomline from the grip to the regulator?

Can i do this?

Also what do u think of the stock trigger of the minimag and the stock barrel?

What barrel do you think I should get for a good deal:

Smart Parts Big Daddy $64.95
Dye Aluminum $39.95
Dye Stainless Steel $74.95
J&J Ceramic $39.95
Smart Parts All American Two Piece with Stainless Steel backend $39.95

I want a barrel that is quiet and very accurate from close to far away shots. Also what do u think is more accurate the All American 2 piece or big daddy?

[Halliday]

You don't HAVE to use the front adapter. You could run the line from the tank straight to the valve hole. Just make sure you set up the hose so it's out of your way. See the pic for an example. You could also have the curve going the other way, but have the hose shorter.

Stock trigger: better than most aftermarket ones

stock barrel: surpisingly good.

Of those barrels, the only one I really know well is the J&J ceramic. It's smaller bore and can be too small for some paint to fit. That is the only barrel that caused chops on my Shocker, becuase the paint was breaking from being rammed in (Big Ball paint)

[AutocockerFreak]

J&J Ceramics are nice! Just no big paint in it. You should get either a 2x trigger ($15) or a benchmark 2x trigger frame(60$) depends on wether or not u need the trigger guard. And you should run the bottom line to the gas thru fore grip then from top of grip to the valve like this

[Soyboy]

Autococker freak. Your minimag is exactly the way i want it! What is exactly the gas thru front grip called and who is it made by and how much does it cost?

[Halliday]

It says in his sig it's an ACI. Should be about $20.

[mamasboy99]

heres mine, lol.

[mamasboy99]

um.what was the question?