help fix

[chandlern1]

i am fixing my friends pmi pro the one with the clear barrel at the bottom of the expanshion chamber is their supposed to be a cap if any one has a picture pleases post!!!!!!!! cauce the co2 is comeing straight out of the bottom:mad:

[PiranhaPro]

First off its a gas through grip.

Second the hose is supposed to be in that hole...if its leaking put teflon tape around the threads.

[Dermen]

Its a regulator unless he changed it. It has the clear barrel which means it is the G3 Pro Ext. You can go to almost any website that sells paintball guns and see a pic of one.

[PiranhaPro]

Sorry, I'm an idiot:) I dont like to read the whole post.

Is it leaking from the hose or from the small allen screw at the bottom of the reg?

[chandlern1]

the small hole i tryed oiling it but hum is sum thing missing

[Dermen]

There is supposed to be a screw in the bottom of the reg so you can adjust the pressure. If that is missing then you will have to buy a replacement or call PMI.

[chandlern1]

its their but is their supposed to be a o ring

[PB_Rhyno]

One of the o-rings on the poppit valve (deep insde the reg) is bad. Take it to your local pro shop and have them install a reg rebuld kit. After they fix it for you, make sure you keep the reg lubed- dry rings is the reason they get damaged.

[chandlern1]

ok ill tellmy friend to get that and to oil it good man my cocker isent even that hard to figure out when it has problems