lp for automag

[Predator2]

I was wondering if you could go lp for the automag. I tend to like lp guns.

[Paintball Monkey]

mags are HP...

[Predator2]

wut about cockers?

[shizocka]

cockers are low pressure, around 400 psi (maybe around 300, im not sure) but i think you can get them lower.

[Predator2]

is there a way to make the mags lp or is it not good for the gun?

[shizocka]

an 8 hole mod will make a little lower pressure

[Predator2]

How low would the pressure be? and is there any other way?

[Paintball Monkey]

mags operate around 800psi, cockers are lower at 500psi stock. I have the ANS Phase II valve in a mag and it has more flow than the 8 hole mod, however the operating pressure is still considerably high. The eight hole mod, the ANS piston body, all are made to have faster recharge rates, not lower the pressure

[Predator2]

how would i make a cocker mor low pressure?

[lssbug]

A Mag does not need low pressure. you can use a screw in bottle around 850 psi and the regulator that built into the mag only uses 375-400psi to opperate.

[Predator2]

could i put a reg. on a mag. Like a PMI Pure Energy? and can i use macroline on it?

[shizocka]

you wouldn't need a reg, but you can use macroline

[lssbug]

the back of the valve is a regulator