My Xtra is wack

[TangFaShow]

ok.... after screwing in a newly filled 20oz c02 tank and playing for about 30 minutes my gun decides to go into full auto mode like it does when it runs out of c02

so then after that i thought my tank was empty... so i screwed in a full 9oz tank i shot a few and it did it again!! what the heck is up with my gun? i would appreciate some help... my gun is a Spyder Xtra

thanks fa show

[Saiyan_warrior]

You might want to check your striker o-rings and oil them a bit.

[P8ntballer]

The grip could be loose, the sear is "dead" or it just needs oiled.

[apoc_101]

check the valve for leaks which would result in lower pressure, check all o rings, check the stiker and sear assemblies, and make sure the gun is well lubed with proper paintball oil. also if you did a trigger job inproperly the sear could be too low. also the grip frame could be loose, resulting in the same effect.

[Pig-Demon]

if you take this the wrong way no offense but my dip**** friend thought the fullauto problem was with his grip. but in all reality i think he had his pure energy reg down too low. he claims his prianha is a lp gun and that it can run off of 300 psi, but frankly he is a dip**** (no offense). just because his gun is $100 more than mine he thinks he is right about all of his problems.( he thinks he has a lp gun because he has a low pressure chamber. ooooo!) if you do have a reg then turn it up. hope it helps.

[Tanker]

I hade this very same problem went on for 2 weeks I would go to the chrono everything is fine, then I get on the field we start playing I pop off 5 to 10 rounds then my gun either goes crazy repid fire or it wont recock I tried everything changed the valve checked every connection

come to find out all it was, was the O-rings on the bolt as the compressed air flowed through and cooled off the gun the orings shunk just enought to screw everything up so I replaced them and havnt had a problem since



I had a problem later with a run away gun that was caused by the trigger frame being slightly loose check that too