Help

[coolafrokid]

Okay i just took my gun apart to clean and oil it but when i reattached everything and tried to shoot the gun it shot once then it sounded like the gun went to fully auto and uncocked adn i was wondering what could be wrong? thanks

[Saiyan_warrior]

Your either out of air or you might want to check your Striker o-rings. Also check if theres any wear on your sear because the sear could possibly not be catching.

[coolafrokid]

I think it might be the sear, how would i be sure if it was the sear? and how would i fix that? thanks

[Dermen]

To check your sear just take the frame off and look at the part that stick out. If it is rounded you need a new one and you should call PMI and they will send you a new one. If your gun has a reg make sure it is letting enough air through. Also make sure your cup seal is on tight.

[coolafrokid]

what is the cup seal? i check the sear and it didnt look too rounded

[coolafrokid]

Never mind the last post i found the cup seal and replaced it just to make sure, i tinkered around some more and i think i might have fixed it but i'm not sure..thanks all for your help

[Saiyan_warrior]

I wouldnt tighten the cup seal to much cause it might strip the threads and cause your full auto problem once again.

[MuckRaker]

I would say that it's either:

A: low on CO2/Nitro
B: need a new o-ring on the hammer/striker.

90% of the time, it's one or both of the above.