hard to put barrels on Pro/Carb with foregrip??? O_o

[ZZ rai]

Is it me, or does it seem it is somewhat hard to put certain barrels on the PC. I mean with the Foregrip and stuff it seems get in the way when sliding on to the barrel? Like putting a 32 degrees Nyte Styke on the PC. And might have unscrew the whole thing to put the barrel on?? :confused:

[PartySquirrel]

yeah you know that screw under the foregrip? just take that out then put the barrel in, hopefully it will work, but if the barrel has 'bumps' on it you might have to grind something, ill get pictures if your not sure which screw im talking about.

[ZZ rai]

yea, thats what i meant to say, if the barrel has bumps. U cant really slide it through the fore grip. what to do what to do :|

[smegle5]

this is a easy question, but its about a a pro-carbine!
yay mor Carbine Power WOOOO!
ok im done

if you have a barrel that dont fit in the shroud, sand down the shroud, NOT THE BARREL! chances are you might want to replace the barrel, u grind it, u cant sell it

[ZZ rai]

wont that make the foregrip all wobblely and loose?:confused:

[smegle5]

its is a lil, but nothing you cant get used to, there is a lil gap between my J&J ceramic and the shroud, but it isnt that hard to get used and doesnt effect youre game at all.

[ZZ rai]

any tips on how i should go about "sanding" the shroud.
maybe i can cut a sqaure, that make it easier :P
but seriously any specific good ways of doing this? and how much should i remove? :eek:

[smegle5]

well, lets not get too into this, what kind of barrel are you lookin at?
most arrels will fit.

[ZZ rai]

mostly lapco bigshot
or
the 32 degree Night Stick

[PartySquirrel]

yeah that will fit fine you wont have any problems (atleast with the bigshot, but the big shot is probably your best bet, unless your wierd and loud barrels bother you)

[smegle5]

go bigshot

most of all of 32* stuff sux

the bigshot is awesom

[Turambar]

If you don't want to keep the rifle grip on the barrel you can chop it off. Just chop it right where the actual grip part ends and you'd be good to go.

[dbs1054]

I have the Armson pro stealth, don't care for it much but you must remove the barrel to remove the fore grip as it will not fit over the end but it is not hard to do.
I also used epoxy to glue the fore grip then sanded it smooth, now there is no gap or uneven areas.

[ZZ rai]

yea thanks guys, i'ma gonna go with the Bigshot. thanks ppl :)