Halo Question...

[csjets14]

Will i need to buy a new feedneck or anything to make a halo B fit on my stock impy... should i even get a halo?? or should i get something else..everyones opinion is wanted.
Thanks Guys

[MrBo]

you will have to sand down the halo for it to fit in stock feedneck.. i would recommend a check it clamping no rise from www.paintballgateway.com.. i have one with my halo, and you have to give a lil push, but halo fits right in it.

[wanabe TOSA]

ya about halos......right now i got a haloB and a high rise feed, an i want to get a no rise or low rise, am i gona have any problems withit not shootin fast enough cus ive heard it has to rev up to 22 bps

o ya - i got eye vision

[blackbobcat87]

ND no-rise. It's smoother than the clamping and much shorter.

[Beatmanias]

i'd recommend either the New Designz halo no-rise or the Check-it clamping low-rise in case in the future you hafta use an egg2/y or zboard or something.

[SPPaintball]

The Halo should fit, but if I were you I would get new ball detents to prevent double feeding.

[ImpulseKid366]

Originally posted by SPPaintball
The Halo should fit, but if I were you I would get new ball detents to prevent double feeding.

i use a twister feed for my halo. i was missing a ball detent (used only one for like a few weeks) and i didnt chop suprisingly.

[Bogforce]

Ihave some trouble with double ball shooting sometimes. I have a question myself can i get a no rise neck with my sanded down halo b.

[TheMexican]

Get a CCM Clamping No-Rise. Its much higher quality than the CiP.

[PhishPhactor]

Originally posted by TheMexican
Get a CCM Clamping No-Rise. Its much higher quality than the CiP.


the ccm in my mind is the best no-rise/feedneck out there. Do it up and buy a CCM. (new slogan?)